The type of unit is often generically called a Ringfeder, even though that’s one of the brands.<\/p>\n\n\n\n The towing eye enters the mouth of the coupling, and the bolt drops through it. Jackknife sensors are not a standard piece of equipment, but if the driver jackknifes the trailer too far, it will bend the towing eye or the drawbar.<\/p>\n\n\n\n To couple the truck to the trailer, the driver ensures the bolt in the coupling is up. The driver reverses the truck until the towing eye enters the mouth of the coupling and hits the back of the coupling. Depending on the unit, the bolt might drop through the towing eye, or the driver may need to get out and do it. The driver then checks that the bolt is through properly and that the locking pin has snapped closed.<\/p>\n\n\n\n The coupling can be damaged by reversing in too quickly, or if the drawbar is too high or low.<\/p>\n\n\n\n Once the trailer is coupled, the air and electrical lines are connected (and hydraulics if it’s a tipper truck). A tug test is performed, then the driver is ready to go.<\/p>\n","protected":false},"excerpt":{"rendered":" There are two main types of trailer coupling used in Australia: a semitrailer which uses a turntable (or fifth wheel) and a truck and trailer which uses bolt coupling device and drawbar with a towing eye. The three most common…<\/span><\/p>\n![\"\"](\"https:\/\/www.driverknowledgetests.com\/resources\/wp-content\/uploads\/2023\/06\/jackknife-sensors-annotated-595x364.jpg\")
![\"\"](\"https:\/\/www.driverknowledgetests.com\/resources\/wp-content\/uploads\/2023\/06\/drawbar-short-3-annotated-595x446.jpg\")
![\"\"](\"https:\/\/www.driverknowledgetests.com\/resources\/wp-content\/uploads\/2021\/07\/bent-drawbar-top-view-2-with-red-dotted-line-595x446.jpg\")